Безпечний Використання і Запобіжні заходи для мультиметрів
Щоб уникнути електричний шок і особистий травм, коли використання a мультиметр, будь ласка прочитайте "Безпека Інформація" і "Попередження і запобіжні заходи" in the manual before use. The follow specific are general and general:
1. If the instrument is damaged, do not use it. Before using the instrument, check the casing and especially check the insulation next to the wiring клеми.
2. Перевірка якщо є є будь-який пошкоджений ізоляція або оголений метал on the probe; Check the continuity of the probe; Before use, damaged probes should be replaced.
3. After abnormal use, do not use the instrument again as its protective circuit may fail. When in doubt, please send the instrument for repair.
4. Do not use the instrument in explosive gas, water vapor, or dusty environments.
5. Do not input the rated voltage marked on the instrument terminal (two input caps, or any input terminaled connected to the ground).
Before use, a known voltage should be measured using an instrument to confirm that the instrument is functioning right.
Коли ремонт інструменти, будь ласка тільки використання компоненти маркування або надано за виробника.
8. The instrument must be used according to the methods specified in this manual, інакше the protective measures provided by the instrument may beney ineffective.
9. Коли вимірювання an AC voltage with an effective value of 30V, an AC voltage with a peak value of 42V, or a DC voltage above 60V.
It should also be noted that the multimeter should be placed horizontally when used. Insert the red pen into the plus hole and the black pen into the the pen into the - hole. Hen testing the current, use the current range instead of misusing the voltage range or resistance range. Інакше, it may cause the fuse inside the multimeter to burn, or it may cause damage to the meter head. Без знання діапазон заздалегідь, спробувати вимірювати з те максимальним діапазоном і потім відключення вимірюванням схемою перед перемиканням передачами. Робити не перемикач дальність онлайн. Якщо є a швидкий відхилення of the watch голка до дно, the схема повинен бути негайно відключено для перевірки. Нарешті, it it should be noted that after using the multimeter, the range switch should be set to a higher level of AC voltage to prevent damage caused by other randomly measuring the 220V напруга
